|
IN-TR-01. Message
displayed "Lock not Installed".
Solution:
While running the software, if the Lock is not
detected properly a message is displayed on the
screen 'Lock not installed on Machine'. Check
whether the Hardware Lock is connected properly
as per the instructions described in IN-FQ-02
IN-TR-02.
Message displayed "Unknown Error".
Solution:
If the Hardware Lock is not installed ,'Unknown
Error' message is displayed after running the
software. Install the USB or Parallel Port Lock
driver as mentioned in IN-FQ-02.
IN-TR-03.
Message displayed "Debug Assertion Failed".
Solution:
If the Active-X components are not registered properly
while installing the software a error will be displayed
'Debug Assertion Failed' on the screen while executing
various commands of Build-Master which are as follows:
1. Random Mesh command in the mesh data dialog box
while drawing a mesh.
2. The ModifyARC / ModifyRCC menus in the Edit Plan
Data option of Floor menu.
In this case run the Register Active-X Components
as explained in IN-FQ-03
IN-TR-04.
Message displayed "Unable to Initialize DAO/Jet
Engine".
Solution:
'Unable to Initialize DAO/Jet db engine' message
is displayed on the screen if the Dao/jet engine
is not initialized properly. Install the MS ACCESS
DAO/ Jet Engine as explained in IN-FQ-04
IN-TR-05.
Message displayed "Failed to create Empty
document".
Solution:
'Failed to Create Empty Document' error message
will be displayed on the screen if the program
is unable to create a new database file. Install
the MS ACCESS DAO/ Jet Engine as explained in
IN-FQ-04
IN-TR-06.
Main Menu Screen doesn't appear.
Solution:
The main menu screen of Build-Master doesn't appears
after the title screen If this happens Press Ctrl
+ Alt + Del only once. The Close Program dialog
box will then appear on the screen. Now Select
Build-Master.Exe Name and Click on End Task. Check
whether the lock is properly installed or not.
IN-TR-07.
Message displayed "Error during the Move
Data Process:115".
Reason:
Sentry files are read only in windows folder.
Solution:
Go to C:\ Windows from Explorer
1) Arrange the files by ‘Name’
2) Look for the file names starting with ‘sentry’
from the list of files.
3) Select all sentry files & right click in
the blue area.
4) Select ‘Properties’ option.
5) A dialog box appears Undo tick to remove Read
attribute & click OK.
6) Again Run setup.exe program
IN-TR-08. Message
displayed "Error 623".
Reason:
Earlier Installation command was run halfway.
Solution : Delete the Build-Master
folder & reinstall.
IN-TR-09. Message
displayed "Cannot Run 16 Bit Application".
Reason:
Problem in your WINDOWS XP Installation.
Solution: Contact your Hardware
Vendor. |
